When glued-laminated timber are subjected to bending moment, they usually fail in a brittle way in the tension zone before the compressive zone reaches the compressive strength of wood. This means that the compression strength of wood is not fully exploited. By reinforcing the tension zone, the failure mode of glued-laminated timber can be changed from tensile to compressive. As a result, by utilizing the higher compressive strength, reinforced glued-laminated timber become stronger and the failure mode becomes compressive and ductile. This paper presents experimental results of the effect of steel reinforcements in the tension zone of glued-laminated timber. Four passively reinforced beams, four actively reinforced beams, and seven unreinforced beams were tested to failure in four-point bending tests. The experimental results confirmed the brittle tension failure in the unreinforced beams as well as the ductile and compressive failure in the reinforced beams. Furthermore, the experiments revealed the increase of the passively and the actively reinforced glued-laminated timber relative to the reference beams for strengths (26% and 39%) and stiffnesses (30% and 11%). Ductilities were increased from 7.7% for the reference beams to 90% and 75% for the passively and the actively reinforced glued-laminated timber, respectively.