A. Shop Drawings and Details for Tests
B. Sound and Impact Test Results Summary
C. Test 1: Sound and Impact Transmission Test - CLT
D. Test 2: Sound and Impact Transmission Test - Concrete Topping
E. Test 3a: Sound and Impact Transmission Test - Marmoleum
F. Test 3b: Sound and Impact Transmission Test - Marmoleum
G. Test 4: Sound and Impact Transmission Test - Carpet
H. Test 5a: Sound and Impact Transmission Test - Luxury Vinyl Plank
I. Test 5b: Sound and Impact Transmission Test - Luxury Vinyl Plank
J. Test 6: Sound and Impact Transmission Test - Mechanical Roof
Two of the major topics of interest to those designing taller and larger wood buildings are the susceptibility to differential movement and the likelihood of mass timber components drying too slowly after they become wet during construction. The Wood Innovation and Design Centre in Prince George, British Columbia provides a unique opportunity for non-destructive...
The Wood Innovation and Design Centre (WIDC) in Prince George, British Columbia, with 6 tall storeys and a total height of 29.5 m, provided a unique opportunity for non-destructive testing and monitoring to measure the ‘As Built’ performance of a relatively tall mass timber building. The mass timber structural system consists of glulam columns and beams with cross laminated timber (CLT)...
Cross-laminated timber (CLT) was developed in Europe for the prefabricated construction of wall, roof, and flooring elements. Adaption of CLT for use in the United States requires consideration of the different climates, building codes, and construction methods in this country. ... This Chapter provides guidance on hear, air, and moisture control in wall and roof assemblies that utilize CLT panels in U.S. climate zones. The overarching strategies are to prevent wetting of CLT panels by using drained wall systems, to control airflow using an air barrier on the exterior of the CLT panels, to place rigid insulation to the exterior of the panels, to prevent moisture from accumulating within the panels, and to allow the panels to dry should they get wet. In certain climates, preservative treatment of CLT is recommended to provide additional protection against potential hazards such as decay and termites. ...
Project contact is Jianhui Zhou at the University of Northern British Columbia
The impact sound perceived in the lower volume in a building is radiated by the vibration of the ceiling transmitted from the vibration of the floor generated by an impact source in the upper volume. Thus, the dynamic behaviour of a floor is one crucial intermediate step to understand the impact sound insulation performance of such a floor. A key to reducing the impact sound is to isolate the structural floor from the subfloor. Floating floor construction is a common way of improving the impact sound insulation, which is to float a concrete topping on the mass timber floor with an elastic layer in between. There are two types of floating floor solutions, a) with a continuous elastic layer and b) with point bearing elastic mounts as shown in Figure 1. This study will investigate both solutions and will provide guidance on how to adopt both solutions for mass timber floors with an exposed ceiling.
The objectives of this project are:
1. To measure the sound insulation performance of mass timber floors with full-scale concrete topping on various continuous elastic interlayer materials
2. To measure the sound insulation performance of mass timber floors with full-scale concrete topping on discrete elastic load mounts
This document aims to emphasize the importance of an appropriate level of on-site moisture management for wood construction, depending on weather conditions, construction methods, and assemblies used. It covers three different but related research projects. It first describes baseline moisture contents (MCs) measured from...