Results from a series of blast tests performed in October 2016 on three two-story, single-bay cross-laminated timber (CLT) structures demonstrated the ability of CLT construction to resist airblast loads in a predictable fashion. These tests were performed on structures without superimposed load to limit inertial resistance. Subsequently, a follow-on series of tests was performed to investigate the response of axially-loaded CLT construction. Panels damaged during the preceding test were removed and replaced. Axial load was applied using precast concrete blocks to simulate the loaded condition of a five-story building at the first-floor front panel of the structures. These test structures were exposed to two shots: the first was designed to keep the structures within their respective elastic ranges while the second was designed to push the structures beyond their elastic limits. Reflected pressure and peak deflections were recorded at the front panels of the test structures to document the two-way panel load distribution behavior under a dynamic load event and the clearing of the shock wave. Prior to conducting the blast tests, a small number of tests were performed on a load tree test apparatus to aid in test planning by investigating the post-peak response of individual CLT panels of various lengths to quasi-static out-of-plane and axial loads applied simultaneously. This paper provides an overview of the results obtained from both the quasi-static and blast tests of axially-loaded CLT. Additionally, the paper compares CLT structure, component, and connection response across the suite of data. Conclusions are offered to assist engineers in the design of load bearing CLT construction exposed to airblast loads.
Cross-Laminated-Timber (CLT) is increasingly gaining popularity in residential and non-residential applications in North America. To use CLT as lateral load resisting system, individual panels need to be connected. In order to provide in-plane shear connections, CLT panels may be joined with a variety of options including the use of self-tapping-screws (STS) in surface splines and half-lap joints. Alternatively, STS can be installed at an angle to the plane allowing for simple butt joints and avoiding any machining. This study investigated the performance of CLT panel assemblies connected with STS under vertical shear loading. The three aforementioned options were applied to join 3ply and 5-ply CLT panels. A total of 60 mid-scale quasi-static shear tests were performed to determine and compare the connection performance in terms of strength, stiffness, and ductility. It was shown that – depending on the screw layout – either very stiff or very ductile joint performance can be achieved.
April 3-5, 2014, Boston, Massachusetts, United States
The second glued-laminated structure built in the United States was constructed at the USDA Forest Products Laboratory (FPL) in 1934 to demonstrate the performance of wooden arch buildings. After 75 years of use the structure was decommissioned in 2010. Shortly after construction, researchers structurally evaluated the gluedlaminated arch structure for uniform loading on the center arch. This structural system evaluation was added to the existing laboratory work on glued-laminated arches to develop the foundation on which the current glued-laminated arch design criteria is based. After 75 years of service and decommisioning, recovered arches were tested in the laboratory to evaluate the loss of structural performance. Loss of structural performance was evaluated by comparing original and current deformation. Based on a preliminary visual and structural assessment, the degradation of structural performance was minimal in the arches, except for two arch that were affected by the building fire.