In this paper, we discuss the structural design of one of the tallest timber-based hybrid buildings in the world: the 18 storey, 53 meter tall student residence on the campus of the University of British Columbia in Vancouver. The building is of hybrid construction: 17 storeys of mass wood construction on top of one storey of concrete construction. Two concrete cores containing vertical circulation provide the required lateral resistance. The timber system is comprised of cross-laminated timber panels, which are point supported on glued-laminated timber columns and steel connections between levels. In addition to providing more than 400 beds for students, the building will serve as an academic site to monitor and study its structural performance, specifically horizontal building vibration and vertical shrinkage considerations. We present the challenges relating to the approval process of the building and discuss building code compliance issues.
April 14-16, 2011, Las Vegas, Nevada, United States
Wood-concrete composite systems are well established, structurally efficient building systems for both new construction and rehabilitation of old timber structures. Composite action is achieved through a mechanical device to integrally connect in shear the two material components, wood and concrete. Depending on the device, different levels of composite action and thus efficiency are achieved. The purpose of this study was to investigate the structural feasibility and effectiveness of using truss plates, typically used in the making of metal-plate-connected wood trusses, as shear connectors for laminated veneer lumber (LVL)-concrete composite systems. The experimental program consisted of two studies. The first study established slip-modulus and ultimate shear capacity of the truss plates when used in an LVL-concrete push out assembly. The second study evaluated overall composite bending stiffness and strength in two full size T-beams when subjected to four-point bending. One beam employed two continuous rows of truss plates and the other employed one row. It was found that the initial stiffness of both T-beams was similar for one and two rows of truss plates but that the ultimate capacity was approximately 20% less with the use of only one row.