This report represents the results of the activities performed in working group 1, Basis of Design. The most important task of working group 1 was the defragmentation and harmonization of techniques and methods that are necessary to prove the reliable, safe and economic application of timber materials or products in the construction industry.
This report is structured into five parts. At first general principles regarding the design formats are addressed (Part I). Afterwords timber specific aspects regarding code calibration (Part II) and serviceability (Part III) are summarized. In Part IV other demanding issues for the implementation into Eurocode 5 are addressed. Here also summaries of joint activities with other working groups on cross laminated timber and timber connections are presented. The report concludes with a guideline for data analysis (Part V).
The results of an experimental programme on the structural behaviour, fire behaviour, and fire resistance of CLT rib panels are presented. The floor system consists of cross-laminated timber (CLT) plates rigidly bonded to glued-laminated timber ribs by means of screw-press gluing.
The experimental programme comprised ultimate-load tests at normal temperature as reference tests and full-scale fire resistance tests on four cross-sections. In addition to the reference tests, shear tests of the glue line between CLT plate and glued-laminated timber rib were performed for analysis of the cross-sections’ composite action.
The results of the reference tests show good agreement with results based on the simplified method according to EN 1995-1-1 [1] and its final draft of CLT design [2]. The importance of the glue line’s quality was confirmed. The fire resistance tests show results on the safe side compared to predictions of the fire behaviour according to EN 1995-1-2 [3] and its actual draft [4]. However, the fire resistance was underestimated due to conservative assumptions about the composite cross-section’s structural behaviour.
The experimental programme addressed the fire behaviour and fire resistance of CLT rib panels currently not covered in standards. The project’s overall aim is the development of design rules in fire for EN 1995-1-2.