To evaluate the bond behavior between glulam and GFRP rods, applied according to the nearsurface mounted strengthening technique, an experimental program composed of beam and direct pullout tests was carried. In this experimental program three main variables were analyzed: the GFRP type, the GFRP location into the groove, and the bond length. From the monitoring system it was registered the loaded and free end slips, and the pullout force. Based on these experimental results, and applying an analytical-numerical strategy, the local bond stress-slip relationship was calculated. In this work the tests are described, the obtained results are presented and discussed, and the applicability of the inverse analysis to obtain the local bond law is demonstrated.
With the aim of evaluating the bond behaviour between glulam and carbon fibre reinforced
polymer laminates strips, an experimental program using pull-out tests was carried, when the near-surface strengthening technique is applied. Two main variables were studied: the bond length and the type of pull-out test configuration. The instrumentation included the loaded and free-end slips, as well as the pullout force. Based on the obtained experimental results, and applying an analytical-numerical strategy, the local bond stress-slip relationship was determined. In this work the tests are described, the obtained results are presented and analysed, and the applicability of an inverse analysis to obtain the local bond law is demonstrated.
Glued-in rod is a type of effective connector for timber structures. In the last decades, considerable researches have been conducted on the bond behavior between timber and glued-in rod experimentally and theoretically. This paper presents the numerical simulation on the bond behavior of glulam joints with glued-in steel rod. Glulam is modelled as the orthotropic elasto-plastic material. Adhesive and steel rods are modelled as isotropic materials. Non-linear spring element was employed to simulate the local bond stress-slip relations at different locations along the bonded length. The numerical results indicate that non-linear spring element can be used to simulate the bond behavior of the glued-in steel rod glulam joints effectively. Moreover, The numerical results obtained by considering the local bond relations at different locations is in a better agreement with the experimental results than that obtained based on the bond stress-slip relation at loaded end.