Timber buildings made with Cross-laminated Timber (CLT) panels are becoming wide spread in Europe. The fire resistance of CLT panels depends upon several parameters, including the number of layers and their thickness. At the present, EN 1995-1-2:2004 does not provide specific information on the fire design of CLT panels. Several fire resistance tests of CLT panels were performed in different scales by furnace testing using the standard fire curve according to ISO 834-1:1999, however the large number of possible combination of CLT products makes testing too complicated and expensive as a tool for the verification of the fire resistance of several combinations. In this report are presented nine small-scale tests carried-out at SP Wood Technology (Technical Research Institute of Sweden). The tests consisted in specimens of CLT and massive timber exposed at a two steps of constant heat flux in a cone calorimeter (50 and 75 kW/m2). Some specimens were exposed with two different types of fire protection (gypsum plasterboard type F and plywood) and some were tested unprotected. Later, thermal simulations with the same set-up of tests were implemented on the finite element software package in Safir 2007, with the time-temperature curve given by ISO 834 as input; also the analytical calculation of the charring depth following the Eurocode 5 part 1-2 was done. The target of this thesis is to compare performed CLT furnace tests with the smallscale cone calorimeter tests carried out, the numerical results of the thermal model and the analytical results obtained.
Project contacts are Arijit Sinha, Andre Barbosa and Barbara Simpson at Oregon State University
The results of this proposal will provide guidance on efficient design and analysis strategies for wood building construction including rocking/post-tensioned and pivoting spines, a next-generation seismic force resisting system, for improved performance, safety, sustainability, and economy. The use of wood in tall buildings is limitied by strength and stiffness considerations. The use of CLT and MPP shear walls, supplemented by energy dissipators may be able to aleviate this problem. Several knowledge gaps exist in terms of the performance of mass timber lateral force resisting systems (LFRS), interconnectivity and compatibility between the modules and LFRS-to-gravity system, and potential hybridization of structural materials for the gravity system and LFRS. The recent 2017 two-story shake table test is the only full scale dynamic on rocking CLT LFRS with energy dissipators. Importantly, since MPP panels are also a recent addition in the mass timber industry, no experimental data exist regarding the self-centering performance of post-tensioned MPP wall panels.
Project contacts are Andre Barbosa and Arijit Sinha at Oregon State University
In order to facilitate adoption of new mass timber products into practice, physical testing is required to understand and predict structural behavior. While extensive testing has been conducted at Oregon State on basic engineering properties of mass plywood panels (MPP) and MPP-to-MPP connections, there exists no experimental data on connections between MPP and other timber members (e.g. glulam) or on composite behavior of MPP with a concrete topping. Previous testing on CLT concrete-composite systems looked at different CLT-to-concrete connection systems, with HBV shear connectors-steel plates partially embedded in the timber with epoxy resin- as a strong candidate in terms of strength and stiffness performance. This project will focus on exploring the performance of MPP-concrete composite systems with HBV connectors.
Wood-based mass-panels (WBMP) are emerging as an attractive construction product for large-scale residential and commercial construction. Australia is following the lead of Europe and North America with several recent projects being completed using predominately cross-laminated timber panels (CLT). These sawn timber-based panels offer some key advantages to the construction and sawmilling industry. However, veneer-based mass-panel (VBMP) systems could offer additional benefits including the more efficient use of the available forest resources to produce WBMPs that have equivalent to superior performance to CLT. Research to confirm the expected technical viability of veneer-based systems is required. VBMPs could provide a valuable contribution, alongside CLT, to the Australian timber products market.