Cross-laminated timber (CLT) became a popular engineered wood product in recent years for highquality and innovative timber buildings. As for any building product, the fire behaviour of CLT panels requires careful evaluation in the design of such buildings. The adhesive used in the bond lines of CLT plays an important role in the fire design. However, currently, European standards do not provide a test method to assess the adhesive performance in CLT exposed to fire. This paper presents a series of fire tests performed with CLT panels glued with different adhesives. It is shown how the mass loss of the CLT panels in standard fire resistance tests can be used to assess the adhesive performance in CLT exposed to fire.
This study explores the use of Cross Laminated Timber (CLT) in a 10-story residential building as an alternative building method to concrete and steel construction. The study is not meant to be exhaustive, rather a preliminary investigation to test the economic viability of utilizing this new material to increase density, walkability and sustainable responsiveness in our built environment.
Based on international precedent, CLT is an applicable material for low-rise, as well as mid-rise to high-rise construction and has a lighter environmental footprint than traditional concrete and steel construction systems. Cross-laminated timber is a large format solid wood panel building system originating from central Europe. As a construction system it is similar to precast concrete in which large prefabricated panels are lifted by crane and installed using either a balloon frame or platform frame system. The advantages to using CLT are many, but the main benefits include: shorter construction times, fewer skilled laborers, better tolerances and quality, safer work environment, utilization of regional, sustainable materials, and reduction of carbon footprint of buildings. As a new, unproven material in the Pacific Northwest, this study investigates the cost competitiveness of CLT versus traditional materials for “low high-rise” buildings.
Fire tests on a double egress fire door installed in two Cross Laminated Timber (CLT) wall panels were conducted. The purpose of the testing was to identify design consideration for detailing the interface between a 90 min. listed door assembly and a CLT wall with a 2-hr fire resistance. See also QAI Laboratories test reports: T895-6a Rev.2, and T895-6b Rev. 1
Fire tests on two unprotected 5-ply Cross Laminated Tmber (CLT) floors with pipe penetrations were conducted. The purpose of the testing was to evaluate concepts for detailing metallic and plastic pipe penetration firestops. Although the focus was on flame through performance, some temperature data was collected on insulated and uninsulated metallic pipes. See also QAI Laboratories test reports: T895-5a, and T895-5b Rev.3
Small furnace fire tests were conducted on CLT cladded with calcium silicate boards, gypsum boards, and combinations of the two. The difference in fire resistance when using different board types, combinations, and thicknesses was demonstrated. Some cross-sectional configurations had enough 2-hour fire resistance performance...
Fire-testing data, such as charring rates and failure modes of structural elements exposed to ISO-standard fires, for unprotected cross-laminated timber (CLT) panels made of domestic timber were investigated to apply the reduced-cross-section method to CLT panels. For the charring rates, a series of fire tests without loading was conducted...
Within the German research project “Fire resistance of primary beam - secondary beam connections in timber structures” solutions for a fire-safe design have been developed. The project concentrated on connections with self-tapping full thread screws and joist hangers. This paper describes the investigations, calculations and experiments on the former type of connections. Herein, a series of loaded fire tests and numerical simulations were conducted with the objective to develop design rules and determine the load-bearing capacity.