The following paper describes the first stage of dynamic testing of a post-tensioned timber building to be performed in the structural laboratory of the University of Basilicata in Potenza, Italy as part of a series of experimental tests in collaboration with the University of Canterbury in Christchurch, New Zealand. During this stage of testing a 3-dimensional, 3-storey post-tensioned timber structure will be tested. The specimen is 2/3rd scale and made up of frames in both directions composed of post-tensioned timber. The specimen will be tested both with and without the addition of dissipative steel angles which are designed to yield at a certain level drift. These steel angles release energy through hysteresis during movement thus increasing damping. The following paper discusses the testing set-up and preliminary numerical predictions of the system performance. Focus will be placed on damping ratios, displacements and accelerations.
In order to address the lack of measured natural frequencies and damping ratios for wood and hybrid wood buildings, and lack of knowledge of vibration performance of innovative CLT floors and sound insulation performance of CLT walls and floors, FPInnovations conducted a series of performance testing at the Wood Innovation Design Centre (WIDC) in Prince George, BC in April 2014, during construction, and in May 2015, after building completion and during its occupation.
This report describes the building, tested floor and wall assemblies, test methods, and summarizes the test results. The preliminary performance data provides critical feedback on the design of the building for resisting wind-induced vibration and on the floor vibration controlled design. The data can be further used to validate the calculation methods and tools/models of dynamic analysis.
A study on the static and dynamic properties of sawn timber beams reinforced with glass fiber-reinforced polymer (GFRP) is reported in this paper. The experimental program is focused on the behavior of unidirectional wooden slabs, and the main objective is to fulfill the service state limit upon vibrations using GFRP when an architectonical retrofitting project is necessary. Two different typologies of reinforcement were evaluated on pine wood beams: one applied the composite only on the lower side of the beams, while the other also covered half of the beams depth. For the dynamic characterization, the natural frequency, damping ratio, and dynamic elastic modulus were measured using two different techniques: experimental modal analysis upon the whole beams; and bandwidth method using smaller samples of the same material. The static characterization consisted on four point bending tests, where elastic modulus, bending strength and ductility were assessed. The lower composite had better ductility and bending strength. On the other hand, the U-shaped laminate showed higher stiffness but also at a higher material cost. However, it allowed some ductility, i.e. compressive plasticity, even in the presence of hidden knots. Both dynamic techniques gave similar results and were capable of measuring the structure stiffness, even if short samples were used. Finally, the changes on dynamic properties because of the GFRP did not jeopardize the dynamic performance of the reinforced timber beams.