Cross-Laminated-Timber (CLT) is increasingly gaining popularity in residential and non-residential applications in North America. To use CLT as lateral load resisting system, individual panels need to be connected. In order to provide in-plane shear connections, CLT panels may be joined with a variety of options including the use of self-tapping-screws (STS) in surface splines and half-lap joints. Alternatively, STS can be installed at an angle to the plane allowing for simple butt joints and avoiding any machining. This study investigated the performance of CLT panel assemblies connected with STS under vertical shear loading. The three aforementioned options were applied to join 3ply and 5-ply CLT panels. A total of 60 mid-scale quasi-static shear tests were performed to determine and compare the connection performance in terms of strength, stiffness, and ductility. It was shown that – depending on the screw layout – either very stiff or very ductile joint performance can be achieved.
International Conference on Structural Health Assessment of Timber Structures
September 9-11, 2015, Wroclaw, Poland
A timber building made of cross-laminated timber (CLT) panels is a modular system where all panels are pre-cut in factory. On site, the single components are then assembled connecting the panels with mechanical fasteners, mainly angle brackets with nails and/or screws, hold-downs, metal plates and self-tapping screws. CLT wall panels are very rigid in comparison to its connections. Thus, connections play an essential role in maintaining the integrity of the structure providing the necessary strength, stiffness and ductility, and consequently, they need close attention by designers. However, there is still a lack of proper design rules for these connections, in particular under cyclic loads, mainly due to a large variety of connectors and connection systems. In this paper, the different properties of connections for CLT buildings, on both monotonic and cyclic behaviour, are described using recent works from different authors. From the bibliography, it is clear that experimental data, regarding both monotonic and cyclic tests, is required for the assessment of the performance of the CLT structural system attending to the interaction between rigid panels and connections. This work evidences results from experimental campaigns and numerical analysis regarding definition and quantification of the cyclic response of CLT connections. Examples regarding monotonic and cyclic tests aimed to evaluate cyclic behaviour of connections through physical parameters, such as the impairment of strength and the damping ratio, are presented and discussed.
The use of cross-laminated timber (CLT) in residential and non-residential buildings is becoming increasingly popular in North America. While the 2016 supplement to the 2014 edition of the Canadian Standard for Engineering Design in Wood, CSAO86, provides provisions for CLT structures used in platform type applications, it does not provide guidance for the in-plane stiffness and strength of CLT shearwalls. The research presented in this paper investigated the in-plane stiffness and strength of CLT shearwalls with different connections for platform-type construction. Finite element analyses were conducted where the CLT panels were modelled as an orthotropic elastic material, and non-linear springs were used for the connections. The hysteretic behaviour of the connections under cyclic loading was calibrated from quasi-static tests; the full model of wall assemblies was calibrated using experimental tests on CLT shearwalls. A parametric study was conducted that evaluated the change of strength and stiffness of walls with the change in a number of connectors. Finally, a capacity-based design procedure is proposed that provides engineers with guidance for designing platform-type CLT buildings. The philosophy of the procedure is to design the CLT buildings such that all non-linear deformations and energy dissipation occurs in designated connections, while all other connections and the CLT panels are designed with sufficient over-strength to remain linear elastic.