The feasibility of manufacturing cross-laminated timber (CLT) from southern yellow pine (United States grown) treated with micronized copper azole type C (MCA-C) preservative was evaluated. Lumber (2x6 visually graded no. 2 boards) was treated to two retention levels (1.0 and 2.4 kg/m3 ), planed to a thickness of 35 mm, and assembled along with an untreated control group using three adhesive systems following product specifications: melamine formaldehyde (MF), resorcinol formaldehyde (RF), and one-component polyurethane (PUR). Block shear and delamination tests were conducted to examine the bonding performance in accordance with ASTM D905 and ASTM D2559 Standards, respectively. One-way analysis of variance and Kruskal-Wallis H test were conducted to evaluate the effects of preservative retention and adhesive type on block shear strength (BSS) and wood failure percentage (WFP). Regardless of adhesive type, the 1.0 kg/m3 retention treatment significantly lowered BSS compared to the untreated control. CLT composed of the laminations treated at 2.4 kg/m3 maintained BSS when PUR and RF were used but not MF. The average WFP of each CLT configuration ranged from 89% to 99%. The untreated CLT specimens did not experience any delamination under accelerated weathering cycles. The delamination rates of the treated specimens assembled using MF and RF increased with the preservative retention level, while PUR provided delamination rates less than 1% to the laminations treated at both levels. These combined data suggest that, under the conditions tested, PUR provided overall better bonding performance than MF and RF for MCA-C treated wood.
Cross-laminated timber (CLT) is a wood panel product that can be arranged in different ways. The advantage of utilizing CLT is the ability to use lamination even with low density materials or those that have defects, like knots. This study evaluated the bonding and bending performances of CLT utilizing domestic species in a shear wall or floor via a face bonding test of layers and a three-point bending test. The tests were carried out with three-layered CLT made up of Japanese larch and/or Korean red pine in various configurations. The layer arrangement for lamination was divided according to the species and grade of the wood. The out-of-plane and in-plane bending tests were conducted on the CLT according to the applicable direction in a wooden structure. The results of the bonding test showed that the block shear strength and delamination of all types of CLT met the BS EN 16351 (2015) standard requirements. The results of the bending test based on two wood species showed that the bending strength of the larch CLT was higher than that of the pine CLT in single species combinations. For mixed species combinations, the bending properties of CLT using larch as the major layer was higher than those using pine as the major layer. This demonstrated that the major layer had more influence on the bending properties of CLT and that Korean red pine was more suited for the minor layer of CLT.